QVGA 2.2" (240x320) TFT SPI display with SD-CARD pinout

The QVGA 2.2" TFT SPI display was bought from Ebay. The display driver is ILI9341 and the board uses 3.3V logic.
The maximum color depth this TFT supports is 16 bit.
The SD-CARD is powered from the display VCC and has separate SPI pins.

Warning! The QVGA 2.2" TFT does not support 5V on either of its pins.



The TFT display pins:

SDO (MISO)
LED = 3.3V or in series with a 100 ohm resistor from 5V
SCK (CLOCK)
SDI (MOSI)
D/C (DATA/COMMAND)
RESET
CS (CHIPSELECT)
GND
VCC = 3.3V

The SD-CARD pins:
SD_CS (CHIPSELECT)
SD_MOSI (MOSI)
SD_MISO (MISO)
SD_SCK (CLOCK)



References: ILI9341 PDF manual, www.instructables.com

No comments:

Post a Comment